![]() For cold climates use 67% (2:1) volume, concentrations above 67% volume are not recommended and give no advantage. In line with most car manufacturers TecLub recommends a 50% (1:1) volume solution for optimum performance. In order to provide a satisfactory level of corrosion protection it is recommended to use at least 33% (1:2) volume of Coolant Concentrate G12, G12+ in the coolant solution. The freeze protection afforded by the various dilutions is detailed in the table below: OAT Coolant (vol %) TecLub recommends that for optimum performance distilled or deionized water is used. These are typical properties and do not constitute a specification, for specification limits please refer to product specification.Ĭoolant Concentrate G12, G12+ is a concentrated product and should be diluted for use with good quality water. Original Equipment Manufacturers’ (OEMs) recommendations should be followed when replacing coolant. Coolant Concentrate G12, G12+ is an extended life antifreeze which should be replaced every 5 years or every 250.000 km for passenger vehicles or every 1.000.000 km for trucks and commercial vehicles. Suitable for both petrol and diesel engines. The following OEM specifications are met by Coolant Concentrate G12, G12+: OEM ![]() Meets most European and International Standards.Ĭoolant Concentrate G12, G12+ exceeds most of the European and International quality standards:.Protection against frost, depending upon the concentration chosen.Improved anticorrosion protection of all metals and alloys used in the cooling system of modern vehicles, especially the aluminium.Elimination of abrasives solids, which gives a better protection of the joints of the water pump.Elimination of deposit problems caused by use of hard water.Thermal characteristics that permit effective engine cooling without boiling.Increased life time, allowing less frequent maintenance, thanks to the corrosion inhibitors which have a very low depletion rate.
0 Comments
Leave a Reply. |